![]() ![]() Grab both ends of the click ring between your thumb and forefinger and gently pull the ring open. If you try to open the ring at the hinge, it will not work. The easiest way to open a click ring is to grab it by the side that clicks open. All you have to do is click open the ring, change it, and close it. ![]() Never open a segment ring by pulling the ends apart, this way you will deform the ring and no longer be able to wear it.Ī click ring makes it much easier to change your piercing jewelry. Make sure that the opening is big enough for your piercing, change your piercing and bend the ends back together. You can open a segment ring by bending the ends to the side. Segment rings are great piercing rings to wear if you don't change them too often. After the change, turn the ball back on and you're done! You can now change your piercing jewelry. Hold your piercing rod with one hand and loosen the ball with the other. The gloves provide a better grip on the jewelry, which makes changing it a lot easier. Take your time and wear rubber (cleaning) gloves. In the mirror, it's reversed and that can be confusing! Try to think of it in the same way as when you tighten or unscrew the cap of a bottle.Ĭhanging your piercing when the jewelry is still attached through the hole in your skin requires a little more practice. Which way do you have to unscrew to get your piercing loose? Seen from above, you tighten your piercing clockwise and loosen it again. It is more difficult to hold onto a screw-on piece with an unusual shape, but by turning the rod instead of the figure, it usually works. Screw the ball back on after the switch and you're done! If you are wearing a different figure (such as a feather, flower or cluster) then twisting/turning the piercing rod instead of loosening the figure might work better. Then loosen the piercing ball and place it in a container. Hold on to the piercing rod on one side between your thumb and forefinger. Labrets, barbells and other threaded rods Leave the jewelry on until your piercing is completely healed. Is your piercing irritated or not healed enough? In that case, changing your jewelry is rarely a good idea. This is certainly a risk with internally threaded jewelry. You might use too much force and twist the thread. Need even more grip? Wear nitrile gloves, so you have an even better grip on your jewelry.ĭo you change the jewelry above the sink? Then place a towel in it to prevent the ball or piece of jewelry from disappearing into the gutter or bouncing out of the sink and ending up on the floor.Ĭhanging bars with screw-on figures? Hold the accessory tightly and turn the rod to release your jewelry.ĭo not use pliers to turn the ball on the rod. Slippery jewelry? Clean them with some (piercing) soap and pat them dry with clean kitchen paper, so you have a better grip. We will explain and guide you through it below. Opening or closing piercing jewelry may seem difficult, but it doesn't have to be! It can be a bit tricky at first, and although you might prefer to leave it to someone else, it’s easy once you find out how to do this yourself. In order to do so, you will first have to open your piercing or loosen it. We often get the question of how to change piercings. ![]()
0 Comments
Leave a Reply. |